An inbound access route can be configured to allow access to the Com.X device from particular devices on the external internet.
Field |
Description |
Source Zone |
In a redirect rule, the source will always be in the internet zone, so this field has been preconfigured and can not be edited using the rule wizard. |
Source IP address |
Access to this rule can be limited to a single IP address or a range of IP addresses on the same subnet. |
Source start port |
The start port of the source which you would like to be able to access this rule. |
Source end point |
The final port of the range of ports on the source which you would like to be able to access this rule |
Destination Zone |
The allocated zone of your destination device. As this is an inbound access rule, the zone is pre-configured to Com.X and can not be edited from the rule wizard. |
Protocol |
The communication protocol that will be available on this rule. Select between tcp and udp. |
Loglevel |
The logging tag you would like attached to any logging on this route. |
Enable |
An Enable toggle. If unchecked, the rule will not be active. |
Description |
An optional description for the firewall rule. |