2Double-click an ethernet interface and select the Servers tab.
Field |
Content |
Comma Start Address |
The start address for the range of IP addresses to allocate to new Comma units. Once a unit has been assigned an IP, the system will remember this assignment, across restarts, and will always reserve the IP for that unit. The IP will no longer be served to future commas. |
Comma End Address |
The end address for the range of IP addresses to allocate to new Comma units. |
Apply the configuration.
Note: On Com.X 1 and Com.X10 units, the eth3 interface is the internal ethernet bus serving the Com.X Media processor card and should not changed from its factory configuration. |