Global Settings

Wanderweb voice interface 1

The primary interface through which the unit reaches www.wanderweb.net through the internet.

Wanderweb voice interface 2

The secondary interface through which the unit reaches www.wanderweb.net through the internet.

External Address

If specified, outgoing SIP packets will include this address as the source address of the SIP packets.

External is Dynamic

When true, indicates that the SIP source host specified should be treated as a dynamic host. This informs the remote peer to resolve the address of the host for each dialog, in case the address has changed.

Additional local subnet

The subnet (IP and subnet mask in the form A.B.C.D/E.F.G.H) for any additional local subnet. Traffic on this subnet will be treated as local by the Com.X for SIP purposes.

Jitter Buffer Enabled

When enabled, a SIP jitter buffer will be instantiated for each SIP call.

Jitter Buffer Max Milliseconds

Indicates the maximum number of milliseconds that the jitter buffer is allowed to buffer media before streaming out.

Jitter Buffer Adaptive

When enabled, uses an adaptive buffering algorithm that adjusts to the media stream conditions. When disabled, the jitter buffer length is fixed to the maximum value specified.

Match Digit Timeout

The timeout in milliseconds after which, if no additional digit is pressed, the dialed digit series is deemed complete and the call is attempted.

Notification email

Email address to which to send system notifications .

SMTP host

The mail relay server to use when sending emails (including notification emails and voicemail to email.)

Please see section 6.3 for a detailed discussion on email services.

SMTP port

SMTP host network port, default is 25

Masquerading domain

The domain to masquerade from when sending emails.

SMTP user

SMTP authentication user to use for sending email via the SMTP host

SMTP password

SMTP authentication password

iTA extra FIFO

Provides additional receive FIFO buffers (4ms instead of 2ms) for analogue and PRI channels on attached iTAs in case of network slips

Gateway recording

If enabled, all calls on all trunks via the Com.X will be recorded.

Please see section 3.13.5 for a detailed discussion on gateway recording.

Gateway recording encryption

If enabled, all calls on all trunks recorded will be encrypted using the Com.X system’s unique hardware key. Recordings can only be decrypted on the same system, or using the system’s unique hardware key.

FOP only available to Operator

If set to true, this will restrict access to the Flash operator panel to the operator extension set in the general settings page of the advanced menu. Please see Section 6.18 for more detail on the operator panel.

Ringback on transfer busy

Enabled by default. If enabled, calls that are transferred to a busy extension will ring back to the transferring extensionRingback on transfer no answer

Ringback on transfer no answer

Enabled by default. If enabled, calls that are transferred to an extension and then unanswered, will ring back to the transferring extension.

Ringback on transfer voice prompt

Enabled by default. If enabled a caller will hear a short “extension unavailble, one moment please” message before a call rings back to the transferring extension.